Teledyne-lecroy VirtualProbe Manuel d'utilisateur

Operator'sManualVirtualProbeSoftware

VirtualProbe SoftwareBlock Setup DialogThe Block Setup dialog is displayed when you touch a Block definition button. It is used to configure thecorres

Operator's ManualTransmission Line - Select to use a lossless transmission line modeled by its delay and characteristicimpedance.Touchstone File

VirtualProbe SoftwareMapping for two-port network specified in two files.VirtualProbe (XTalk) Crosstalk BlockWhen the Crosstalk package is present on

Operator's Manualis when you wish to understand how a signal would look if the path between the trans-mitter and receiver were to be extended by

VirtualProbe SoftwareWarnings and Error MessagesIf all lanes are not setup as 4 port, Channel in the VPSetup dialogs for each lane, then a message wi

Operator's Manuall All frequencies are assumed to go from the first frequency listed to the last frequency listed withconstant frequency spacing.

VirtualProbe Software Operator's Manual© 2013 Teledyne LeCroy, Inc. All rights reserved.Unauthorized duplication of Teledyne LeCroy documentation

Operator's ManualTABLE OF CONTENTSVirtual Probe Overview 2Virtual Probe Process 2Choose Your Mode of Operation 3VirtualProbe, EyeDoctor-VPand Ey

VirtualProbe SoftwareVirtual Probe OverviewThe Teledyne LeCroy Virtual Probesoftware option lets you view waveforms as they would appear in cir-cuit l

Operator's Manuall Identify the position of a "virtual probe" that outputs the waveform that would be seen at theselected position .l W

VirtualProbe SoftwareModeling the CircuitVirtualProbe Main DialogThe VirtualProbe main dialog is used to select an active setup/lane and configure the

Operator's ManualStatus LED - An LEDnext to the Apply button indicates the status of the VirtualProbe setup for theselected lane.Setup Status LE

VirtualProbe SoftwareSetup DialogThe Virtual Probe Setup dialog configures the overall settings for the circuit represented by the selectedsetup or la

Operator's ManualNOTE:there is no need to configure a math function to be the difference between two inputs when usingVirtualProbe.SDAIII-COMPLE