Teledyne-lecroy Voyager Exerciser Generation Script Language Manua Manuel d'utilisateur télécharger pdf (Page 162)

Teledyne LeCroy Voyager USB 3.0 Exerciser Generation Script Language Reference Manual

153

Bit Location

Attributes

1: LTSSM will remove Rx termination upon receiving Warm

Reset LFPS signaling.

Default value is 0.

U3EX (U3 Exit)

0: U3 Exit handshake works normally

1: Use controlled behavior for U3 Exit response (Refer to

LTSSM_U3EXIT_CONTROL).

HRST

This bit just affects Device mode.

0: Device will pass HotReset.Active fast just by sending

minimum required TS2s with Reset bit asserted.

1: Device will remain in HotReset.Active and continue

sending TS2s with Reset bit asserted till the timeout

specified by LTSSM_HOTRESET_TIME expires.

RxDET

This bit enables controlled behavior in RxDetect state.

0: RxDetect works normally according to the spec.

1: Use controlled behavior for RxDetect (Refer to

LTSSM_RXDETECT_CONTROL)

31:10

Reserved, filled by 0

12.1.12 LTSSM_U3EXIT_CONTROL

(Offset in the Register Area: 0x0214)

This register contains U3 Exit controlled behavior parameters; Denial Count and Delay Time. Values

specified by this register are used when U3EX bit of

1 2 ... 157 158 159 160 161 162 163 164 165 166 167

Pas de commentaire

Teledyne-lecroy Voyager Exerciser Generation Script Language Manua Manuel d'utilisateur Page 162