Teledyne-lecroy PETrainer Scripting Language Reference Manual Manuel d'utilisateur télécharger pdf (Page 7)

Teledyne LeCroy PETrainer Scripting Language

2 Command List

COMMAND MODIFIERS Comment

Packet TLP, DLLP, OrderedSet, Raw,

Sends a packet.

Idle <# of ns> Sends idle symbols (D0.0).

Link L0, L1, L0s, HotReset, Disabled,

Recovery, Detect, LTSSMOff, InitFC

Sets a link condition.

Config General, FCTx, FCRx, TLP, AckNak,

Transactions, Link, Definitions

Configures the PETrainer™

Wait TLP, DLLP, Error, LinkCondition,

BOB, Payload, User

Waits for the condition specified.

Include <Include file path>

Includes a PETrainer script file.

Branch TLP, DLLP, Error, Link, BOB,

Payload, User

Enables/disables an interrupt for

the specified condition.

Proc Begin, End Declares the procedure to be

used in a branch statement.

Loop Begin, End

Creates a PETrainer loop.

Repeat Begin, End Repeats traffic some number of

times.

Template TLP, DLLP, OrderedSet, Raw,

Creates a template for a packet

that can be used in the Packet

command.

AddressSpace Read, Write Reads/Writes address space.

FastTransmit Setup, Start, Pause, Continue, Stop

Defines and controls high-

performance generation.

Note: Available only for the

Summit Z2-16™ and Summit Z3-

16 Trainers.

Send

MRd32, MWr32

MRd64, MWr64

Defines a sequence of packets to

send once, a number of times, or

repeatedly. Available only in a

Setup command section of a

FastTransmit block.

Note: Available only for the

Summit Z2-16 and Summit Z3-16

Trainers.

1 2 3 4 5 6 7 8 9 10 11 12 ... 88 89

Commentaires sur ces manuels

Pas de commentaire

Teledyne-lecroy PETrainer Scripting Language Reference Manual Manuel d'utilisateur Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Équipement Teledyne-lecroy PETrainer Scripting Language Reference Manual