Teledyne-lecroy QPHY-PCIe Manuel d'utilisateur télécharger pdf (Page 13)

QPHY-PCIE Operator’s Manual

General Setup

The first sub-dialog contains general system settings. These remain in effect for each session,

regardless of Standard, until changed.

Connection tab

Shows IP Address of the oscilloscope (local host 127.0.0.1 if QualiPHY is run from the

oscilloscope). The Scope Selector allows you to choose the oscilloscope used for testing when

several are connected to the QualiPHY installation. See Set Up Remote Control

for details.

Session Info tab

Optional information about the test session that may be added to reports, such as: Operator

Name, Device Under Test (DUT), Temperature (in °C) of the test location, and any additional

Comments. There is also an option to Append Results or Replace Results when continuing a

previous session.

To optimize report generation, enter at least a DUT name at the beginning of each session.

Report tab

Settings related to report generation. Choose:

• Reporting behavior of:

o “Ask to generate a report after tests,” where you’ll be prompted to create a new

file for each set of test results.

o “Never generate a report after tests,” where you’ll need to manually execute the

Report Generator to create a report.

o “Always generate a report after tests,” to autogenerate a report of the latest test

results.

• Default report output format of XML, HTML, or PDF.

• A generic Output file name, including the full path to the report output folder.

Optionally, check Allow style sheet selection in Report Generator to enable the use of a

custom .xslt when generating reports (XML and HTML output only). The path to the .xslt is

entered on the Report Generator dialog.

Report Generator launches the Report Generator dialog, which contains the same settings as

the Report tab, only applied to individual reports.

Advanced tab

This tab launches the X-Replay Mode dialog. See X-Replay Mode.

About tab

Information about your QualiPHY installation.

922543 Rev Error! Reference source not found. 9

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 29 30

Pas de commentaire

Teledyne-lecroy QPHY-PCIe Manuel d'utilisateur Page 13