Teledyne-lecroy Serial Data Debug Solutions Manuel d'utilisateur télécharger pdf (Page 21)

Operator's Manual

919586 RevA

 Checkboxes - Touch items to check the box and include them as table columns for a particular protocol.

 BitRate Tolerance - Some protocols have a Bit Rate Tolerance setting. This can be set to any value from

0.01% to 10%. If the bit rate is outside the tolerance range set, then the calculated bit rate appears in red

text on the table.

Protocols with a wide variance of bit rates, such as I

C (which often has clock stretching) do not have this

feature.

 Default - Press the Default button to reapply standard settings for a particular protocol.

SEARCHING FOR MESSAGES

There are several ways to search for specific messages. The following are all valid ways to search messages.

 Touch the decoded waveform. A pop-up dialog is shown where you can select Decode Search as follows:

 Touch the Search button in the Serial Decode Summary dialog box or the Decode Setup dialog box.

 Go to Math → Zoom Setup... from the Menu Bar to turn a Zoom ON, define its source, and search

directly.

Any of the aforementioned methods show the Zoom dialog box and a corresponding Search dialog box on the

right side.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 203 204

Pas de commentaire

Teledyne-lecroy Serial Data Debug Solutions Manuel d'utilisateur Page 21