Teledyne-lecroy CANbus TD and CANbus TDM - Operators Manual Manuel d'utilisateur télécharger pdf (Page 36)

CANbus Trigger, Decode, and Measure

CANbus-TD-TDM-OM-E RevB

In addition, some optional LeCroy programs add the capability to produce larger histograms and

trends of your measurement parameters. If you have this capability, then you can access it

through the Measurement Parameter setup dialog (the Px tab).

Pass/Fail Analysis with Measurement Parameters

Pass/Fail analysis using measurement parameters is simple to set up and powerful. For

instance, you can define a timing measurement, define the limits for the timing measurement,

and then run the oscilloscope in a Normal trigger mode, capturing thousands of measurement

events. Then, Pass/Fail can be used to save the waveform in the event of a Fail, or send an

email in the event of a fail.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 68 69

Pas de commentaire

Teledyne-lecroy CANbus TD and CANbus TDM - Operators Manual Manuel d'utilisateur Page 36