Teledyne-lecroy CANbus TD and CANbus TDM - Operators Manual Manuel d'utilisateur télécharger pdf (Page 53)

Operator's Manual

CANbus-TD-TDM-OM-E RevB

3. Connect the CANbus TD/TDM Oscilloscope

Interface Module (OIM) to the EXT input of

the instrument. Make sure that the top

(OIM labeled side) is facing up.

Note: Make sure that the OIM is at a right angle

to the connector.

4. Connect the 3-pin plug end of the OIM to

the Trigger Module.

Installing Trigger Couplers

UNDERSTANDING WHICH TRIGGER COUPLER IS INSTALLED IN THE TRIGGER MODULE

The Trigger Coupler is a CAN Transceiver. Therefore, the Trigger Coupler in the Trigger Module

must match the transceiver in the CAN circuit you wish to connect to. If it does not match, the

CAN trigger will not function properly.

To identify the coupler(s) that are installed, do the following:

1. Open the CAN Trigger dialog by touching the Trigger descriptor

box (or by pushing the front panel “Bus Analysis” push button

on Vehicle Bus Analyzers, and then selecting the CAN Trigger

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 68 69

Pas de commentaire

Teledyne-lecroy CANbus TD and CANbus TDM - Operators Manual Manuel d'utilisateur Page 53